All FAQs (1904 total: showing 821-840)
- What would cause a message from LoggerNet that the settings are locked by a user?
- Using LoggerNet, what kind of file format checking occurs?
- Does a user need to be permanently logged in to LoggerNet for the software to run and data to continue to be received?
- Does LoggerNet stay connected to the datalogger after the scheduled collection is finished?
- How long does it take to install LoggerNet?
- Is there a Macintosh version of LoggerNet?
- Can backups from older versions of LoggerNet work on newer versions?
- How much memory does LoggerNet have?
- Can a single copy of LoggerNet be purchased and installed on a laptop PC and a desktop office PC, or are two copies of LoggerNet needed?
- Are LoggerNet upgrades free?
- Where is there information about the revisions to the LoggerNet software?
- Is LoggerNet included with the purchase of a datalogger, or is the software sold separately?
- Where is there information about the revisions to the SCWin software?
- Can Short Cut be used to write a program for the CS470, CS471, CS475, CS476, or CS477 even though none of them are listed as an available sensor in Short Cut?
- Can a CS470 or CS471 be used to measure rainfall if the majority of the time there is no water to be measured?
- How large of an enclosure is needed to house a CR1000, a 12 V battery, and a CS470 or CS471?
- Can the 4 to 20 mA analog output on the CS470 or the CS471 be used with a PLC instead of a Campbell Scientific datalogger?
- Using a CS470 or CS471, how can bad measurements be prevented because of river silt or mud?
- What should be done to prevent a CS470 or CS471 from being damaged by the current of a river?
- Do the CS470 and the CS471 require a separate gas pump or gas bottle to drive the system?
Previous
Next