FAQs Frequently asked questions about our products and solutions

How can it be calculated when a datalogger data table will fill up?

One of the simpler ways to approximate how long it will take for a data table to fill up is to open the LoggerNet Connect screen, click the Station Status button, and view the Table Fill Times tab.

This was helpful

FAQs Home

Similar FAQs

Can PC400 be downloaded directly from the Campbell Scientific website?
What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
What is the CRBasic Editor that comes with LoggerNet?
How can a CR1000 or CR3000 interface with a Modbus/TCP device?
How can a CR1000 be connected to a device that uses Modbus RTU over RS-485?
What is ring memory?
How can a CR800 or CR850 be configured to be a Modbus RTU slave without using any of the PC-based Campbell Scientific configuration software?