Toggle navigation
Products
Solutions
Support
About
Home
Products
Solutions
Support
About
Quote List
Contact
Regional Websites
Regional Websites
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Country Directory
Log In
FAQs
Frequently asked questions about our products and solutions
Ask a Question
Ask a Question
Search
All FAQs
(1927 total: showing 741-760)
If the temperature drops below -30°C, is that a problem for the CSAT3?
Is the CSAT3 only compatible with Campbell Scientific dataloggers?
Is the CSAT3 anemometer measurement limited by precipitation?
Can the bubble level on the CSAT3 be replaced?
Can the CSAT3 be used in low-speed conditions, such as less than 5 cm/s? If so, what are the resolution and accuracy at these low speeds?
What are the mounting options for the CSAT3?
Is the offset relatively constant for a single CSAT3?
How often do CSAT3 anemometers need to be recalibrated?
Is there a way to determine the time at which the CSAT3 started reporting data with sub-second precision?
How sensitive are the CSAT3 velocity measurements to sea spray in periods of high wind speed?
Does the head of the CSAT3 need to be matched with its electronic box?
Can the CSAT3 measurement frequency be changed? If so, what frequencies are supported by the CSAT3?
Can the connectors for a PWENC enclosure be purchased separately?
How easy is it to replace a defective component, such as a modem, from inside a prewired enclosure?
What is needed to connect a modem to a datalogger?
Does the CM375 come with anchors?
What if I don’t have a Campbell data logger for use with the CS725?
Can the CS725 output in SDI-12 format?
Can the CS725 sensor be installed once snow is on the ground?
When should the CS725 be installed?
Previous
Next