FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1927 total: showing 721-740)

What is an alternative to using an NL115 or CFM100 and storing data to a card?
Using PC200W, how can a CR1000 be instructed to send data to the SC115?
Is it possible to automatically encrypt the data stored on an SC115?
Can the SC115 be used with an NL115 2 GB card to increase the storage capacity to 4 GB?
What is needed to have the datalogger automatically download data to the SC115?
How can the SC115 be used?
After remotely uploading an operating system, how can the NL201 be reset?
Can the operating system (OS) in an NL201 be updated remotely?
What are the calibration procedures for the CSAT3, and how are they traceable to NIST?
Is the crosswind correction applied to the raw data of the CSAT3?
Are there any corrections to the raw data (not the average data) obtained by the CSAT3?
Can the CSAT3 give a time stamp with each measurement value?
What is the direction definition of vertical wind speed for a CSAT3? For example, does a negative value mean upward or downward?
Can a CSAT3 be made to work in a -80°C environment?
What should be done if the CSAT3 cannot be found in the Short Cut list of sensors?
Are there any datalogger programming changes that must be made to a program when using a long Synchronous Device for Measurement (SDM) cable with a CSAT3?
Can a CSAT3 be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?
If the polymer coating at the ends of the CSAT3 transducers starts coming off, is that a problem?
What is the absolute accuracy of the speed of sound measurement in the CSAT3?
Are there any mounting options for the CSAT3 that lend themselves to frequent repositioning?

Previous Next