FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1904 total: showing 301-320)

If an SR50A-L is used to measure snow depth at a site that has wind, rain, and extreme changes in temperature, which results in condensation, what can be done to ensure the sensor operates properly?
What is the potential error over a range of cold and warm temperatures with the SR50A-L if no temperature compensation calculation is applied to the measurement?
Can an SR50A-L be hardwired to a datalogger that is 2,000 ft away with no direct line of sight?
Can an SR50A-L be used to measure the depth of a body of saltwater?
How can snow depth less than 0.5 m be measured using an SR50A-L?
Can an SR50A-L be used to measure stream flow depth of small ephemeral creeks?
Can the range operation of the SR50A-L be increased?
Can the SR50A-L handle a coastal environment with humidity and salt spray?
What is the maximum cable length available for the SR50A-L?
Can the SR50A-L be used in small-diameter wells?
Can an SR50A-L be connected to a datalogger on an SDI-12 port?
Does the SR50A-L need a temperature probe?
To use the CPEC200 scrub module as a source of zero gas, is it necessary for the CPEC200 system to include a valve module?
Is there a calibration procedure for the PWS100?
At a consistently windy site, is a PWS100 less accurate than a tipping bucket rain gage?
How can a copy of the PWS100 Present Weather Viewing Software be obtained?
What does the Present Weather Viewing Software do? For example, can it save data?
Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
What is the current drain of the PWS100?
How is the PWS100 different from a rain gage or snow depth sensor?

Previous Next