FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1927 total: showing 281-300)

Can the CS11-L be used in a three-phase power situation?
How can the CS11-L be used on a datalogger other than a CR200(X)?
How is the CS11-L an improvement compared to the retired CS10-L and CS15-L?
Can an ST350 be used in instrumental pile load tests with cast-in-situ (bored) concrete piles?
What needs to be done to measure ST350 Strain Transducers using a Campbell Scientific datalogger?
What is the microstrain limit for the ST350?
Is one 4WFBS350 or 4WFBS120 required for each ST350 connected to a datalogger or multiplexer?
How easy is it to replace a defective component, such as a modem, from inside a prewired enclosure?
When the GPSReady variable is not 10, does the datalogger still synchronize with the PPS signal?
If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the datalogger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a datalogger and then parsed out?
How can four GPS16X-HVS receivers be connected to the COM ports of a datalogger to read all four NMEA strings?
What battery options are available for the 25295?
Does the regulator for the 25295 draw power from the battery during the night?
Does the regulator for the 25295 have the Low Voltage Disconnect feature?
What would happen if two dataloggers were connected directly through CS I/O ports via an SC12 cable?
What is the pinout for the SC12 cable?
Can a solar panel provide enough power to charge a weather station?
Can an SC932C be used to replace an SC932?

Previous Next