All FAQs (1902 total: showing 1501-1520)
- If an RF modem is used to communicate with a datalogger and a PC running LoggerNet, but the modem baud rate is one third of the datalogger baud rate, is that a problem?
- Why might a datalogger refuse having a file uploaded to it?
- Is there a free software package that allows the generation of programs that can sample data on the RS-232 or COM port of the datalogger?
- If a datalogger OS has not been upgraded in a long time, can the most current OS be downloaded, or do the upgrades need to be done incrementally?
- Can two dataloggers be connected over the RS-232 port, or do they need to use the COM ports to connect?
- How often is the lithium battery voltage measured by the datalogger?
- If a datalogger has not been used in a while and the internal battery is low, will the battery recharge if the datalogger is connected to a power supply? Or does the battery need to be replaced?
- Is data lost when the datalogger battery runs out of power in the field or is disconnected, and a “table definitions out of date” error message appears upon powering up?
- Which CRBasic instruction is used to activate the 7321 relay?
- Can a datalogger accept PakBus connections from multiple ports simultaneously?
- Can an RS-232 device be directly connected to the CS I/O port of a datalogger?
- How can the datalogger be used to produce analog voltages?
- What is the difference between the various bridge measurements?
- What might cause clock issues?
- What might cause a datalogger to not store data at a particular time, such as midnight?
- What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
- How can variables be saved so that they are available for use after the datalogger power has been removed and the datalogger has been powered up again?
- What is the minimum scan interval of the CR1000, CR800, CR850, or CR3000?
- What is the operating voltage of the CR1000, CR800, and CR850?
- Can a CR800/CR850 and CR1000/CR3000 be connected via a CS I/O port with a null modem cable?
Previous
Next