FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

How can variables be saved so that they are available for use after the datalogger power has been removed and the datalogger has been powered up again?

Use the PreserveVariables() instruction to ensure that all variables reflect the last known value if the datalogger experiences power loss.

This was helpful

FAQs Home

Similar FAQs

What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
What is ring memory?
How can a CR1000 or CR3000 interface with a Modbus/TCP device?
How can a CR800 or CR850 be configured to be a Modbus RTU slave without using any of the PC-based Campbell Scientific configuration software?
What is PakBus encryption?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU slave?
If a CR3000, CR1000, or CR800-series datalogger has a “machine self-calibration failed” message, what does that mean?