CS635-L 3-Rod 15 cm TDR Probe with Low-Loss Cable
High-Conductivity Soils
Up to 25 m cable length
weather applications supported water applications supported energy applications supported gas flux & turbulence applications supported infrastructure applications supported soil applications supported

Overview

The CS635 is used in TDR100-based systems. This probe consists of a Sanoprene head, three pointed rods, and a low-loss LMR200DB cable. The length of each rod is 15 centimeters, allowing the probe to be used in high electrical conductivity soils (maximum soil bulk electrical conductivity 3.5 deciSiemens/meter). The low-loss cable is suitable for lengths up to 25 m as measured from the tips of the probe's rods to the TDR100 reflectometer. A similar probe, the CS630, is available for applications using shorter cable lengths (up to 15 meters). The CS630 and CS635 differ only in their cables.

Read More

Images

Technical Description

The CS635 acts as a wave guide. Impedance along the rods varies with the dielectric permittivity of the surrounding soil. Because the dielectric permittivity of soil primarily depends on the amount of water present, soil volumetric water content can be inferred from the reflected measurements. Soil bulk electrical conductivity is determined from the attenuation of the applied pulse.

Specifications

Maximum Soil Bulk Electrical Conductivity 3.5 dS/m
Rod Diameter 0.32 cm (0.125 in.)
Rod Length 15 cm (5.9 in.)
Santoprene Head Dimensions 5.75 x 4.0 x 1.25 cm (2.25 x 1.57 x 0.49 in.)

Compatibility

Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.

Miscellaneous

Product Compatible Note
SDMX50 (retired)
SDMX50LP (retired)
SDMX50SP (retired)
TDR100 (retired)
TDR200

Related FAQs

Number of FAQs related to CS635-L: 1

  1. In applications where TDR probes are used to measure soil water content, the maximum distance from the TDR probe back to the TDR100 (even through one or more multiplexers) cannot exceed 15 m (50 ft) when using RG58 coaxial cable; the CS605-L, CS630-L, and CS640-L TDR probes have an RG58 cable. When using low-loss coaxial cable, the distance cannot exceed ≈25 m (80 ft); the CS610-L, CS635-L, and CS645-L TDR probes have a low-loss coaxial cable.

    In slope stability and rock mass deformation applications, the maximum coaxial cable length should not exceed ≈1 mile (5,280 ft). The maximum combined length of all SDM cables in the system should not exceed ≈76 m (250 ft).

Listed Under

Other Accessory for the following products: