Hi:
I have a Datalogger CR100 to connect two IR120. However, I have a problem. I need to measure in a plot that is very far from datalogger. So I want to test one IR120 with a Arduino Board. This is possible? Somenoe try something like that?
What kind of code I must to use for it?
Thanks in advanced!
Hi,
I think IR120 is too sophisticated probe to be used with arduino. A few days ago I was curious about ardunino, which I do not know, but I think since as the ADC converter is only 10 bit, you would have a too big resolution.
The remote connection you have with arduous or no, you can use it with other CS logger and get the data to the CR1000 master.
Smile