Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

communication RS485 to CR1000X (protocol modbus)


Minomada Sep 28, 2020 07:54 AM

Hello,

I'm trying to read the data from a device that uses protocol Modbus RTU (Solys gear drive) by connecting the port RS485 device to the CR1000X then store it into the table. 

I use the port ComC7 for incoming data. The device sends the data on the port RS485 every 1 sec. This is the format of the data :

.status=0;SolysGDSom001;2014/10/28;14:26:24;-134.747698;75.851923;0x044;0x6648;

Please could you recommend the CR1000X instruction to capture these data in the datalogger variable? 

Thanks. 

Log in or register to post/reply in the forum.