Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR1000X Ping Keep Aliive Timeout Value Setting

luisfgranada Sep 2, 2020 01:36 PM

Hello,

Does anyone know if something has changed since firmware v4.00 regarding "Ping Keep Alive Timeout Value" setting?

I was able to set this parameter to a value other than "Disabled" in v3.02. Since firmware v4.00 (CR1000X), everytime I change this setting (i.e. 30 min), and then apply (Device Configuration Utility), when I connect again to the datalogger this setting will be Disabled.

Thanks.

Log in or register to post/reply in the forum.