Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Dynasonic Transit Time Flow Meter (TFXL) loggernet program for CR1000

Dennise Mar 8, 2018 05:13 PM

Does anyone have a CR1000 (or CR6, CR3000) loggermet program for a Dynasonics Transit Time Flow Meter (TFXL) by badger?

The output for this one is a Totalizer pulse:

Signal One pulse for each increment of the totalizer’s least significant digit
Operation Normal state is high; pulses low with display total increments
Pulse Duration 30 mSec/minute
Source / Sink 2 mA maximum
Logic 5V DC

https://www.badgermeter.com/resources/e75e37be-f229-465f-b05f-a8989a118d82/transit%20time%20ultrasonic%20flow%20meters%20tfxl%20manual%20ttm-um-00369-en.pdf/

JDavis Mar 8, 2018 05:23 PM

PulseCount on a P channel in switch closure mode should be able to read it. Totalize the counts in your program.

Log in or register to post/reply in the forum.