FAQs Frequently asked questions about our products and solutions

In a CR5000 program, what is the best way to create two separate scans running in PipeLineMode?

Only one scan may be executed in the main scan. However, additional scans, running at longer scan intervals, may be added to a program using the SlowSequence instruction.

This was helpful

FAQs Home

Similar FAQs

What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
Can the CR6 have simultaneous communications (that is, Ethernet and USB) at the same time between two different computers?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU slave?
Is LoggerNet software needed to download the data from a datalogger remotely?
Can a datalogger be used for logging binary data and hexadecimal data?
What makes the CS616-L an improved sensor over the CS615-L?
Using RTMC Pro, is there a way to set up email alerts for a complete datalogger failure?