FAQs Frequently asked questions about our products and solutions

Can a CR800 wiring panel be used on a datalogger other than the original datalogger?

The CPU of the datalogger can be removed and mated with a different CR800 wiring panel. This can be done by removing the four corner nuts on the underside of the CR800. Do not loosen the two middle nuts. Be careful not to damage the pins mating the CPU with the wiring panel.

This was helpful

FAQs Home

Similar FAQs

What do “serial port open failed” and “permission denied” error messages mean?
Can PC400 be downloaded directly from the Campbell Scientific website?
What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
How can a CR800 or CR850 be configured to be a Modbus RTU slave without using any of the PC-based Campbell Scientific configuration software?
What is PakBus encryption?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU slave?
If a CR3000, CR1000, or CR800-series datalogger has a “machine self-calibration failed” message, what does that mean?