FAQs Frequently asked questions about our products and solutions

Where are the holes in the CR3000 to attach it to the backplate of an enclosure?

The base of a CR3000 has four rubber feet. Remove the feet to expose the four holes in the base. Remove the CR3000 datalogger from the base, so that the mount screw (pn 505) can be passed through the base into the grommet (pn 6044) on the enclosure backplate.

This was helpful

FAQs Home

Similar FAQs

What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a datalogger and a PC using a serial or USB to RS-232 cable?
How can a CR1000 or CR3000 interface with a Modbus/TCP device?
What is PakBus encryption?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU slave?
If a CR3000, CR1000, or CR800-series datalogger has a “machine self-calibration failed” message, what does that mean?
Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple dataloggers?