FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

Is LoggerNet Admin needed to automatically start up LoggerNet on a virtual server?

Yes, unless a Windows task is set up to launch LoggerNet. This task method, however, is not supported by Campbell Scientific.

This was helpful

FAQs Home

Similar FAQs

What do “serial port open failed” and “permission denied” error messages mean?
Can PC400 be downloaded directly from the Campbell Scientific website?
What is the CRBasic Editor that comes with LoggerNet?
How can a CR800 or CR850 be configured to be a Modbus RTU slave without using any of the PC-based Campbell Scientific configuration software?
What does the error "Classic::CmdClockSet" mean?
Where are skipped records for the datalogger reported?
What is needed to run LoggerNet as a server and control two datalogger networks from remote PCs? Is LoggerNet Admin needed, as well as LoggerNet Remote for each remote PC?