FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1927 total: showing 981-1000)

How can more data for water analysis be acquired?
What communications options can be used with a water sampler?
What type of analysis can be done at the water sampler site?
How are automatic water samplers affected by altitude?
Is the ST-21 designed for use in single- or multi-channel communications via wire (line), coaxial cable, or optical fiber cable?
How much data can be transmitted per day using the ST-21?
Can an ST-21 be used for both transmitting and receiving data?
How are data downloaded using satellite communication?
What type of field check can be done on a temperature sensor or a temperature and relative humidity sensor to determine if it is within the range of specified accuracy or if it requires calibration?
Can the fan of the ASPTC-L be turned off when the temperature falls below -10°C?
Why does the ASPTC-L have a minimum operating temperature of only -10°C, when most of the Campbell Scientific products are rated down to -30°C or colder?
Can the ASPTC-L and a sonic anemometer be used to measure high-frequency temperature fluctuations needed to find sensible heat flux using the eddy-covariance technique?
Should the ASPTC-L fan(s) be turned off at night to save power?
If the thermocouple in the ASPTC-L breaks, can it be replaced in the field?
What might cause a connection issue between a datalogger and an NL240 in LoggerNet?
How can two dataloggers be connected to a single NL240 device?
Is the NL240 compatible with a WPA-Enterprise network?
Does the NL240 come with a whip?
Can an NL201 or NL240 be powered from a datalogger CS I/O port?
How many LWS-L sensors can be connected to an AM16/32B multiplexer?

Previous Next