FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1927 total: showing 921-940)

What are the major differences between a CH100 and a CH200?
How can a tower and crossarm configuration be made more stable?
Is there a way to only record measurements during the daytime and put a CR200X-series datalogger in sleep mode during the nighttime to conserve power?
If a CR200X-series datalogger has not been used in a while and the internal battery is low, will the battery recharge if the datalogger is connected to a power supply? Or does the battery need to be replaced?
Instead of saving the data of a CR200X-series datalogger to one large file, how can it be saved in daily, hourly, or half-hourly files?
How do the AM25T and the AM16/32B compare with regard to programming?
How do the AM25T and the AM16/32B compare with regard to flexibility?
How do the AM25T and the AM16/32B compare with regard to their relays?
How do the AM25T and the AM16/32B compare with regard to relay wear and tear?
How do the AM25T and the AM16/32B compare with regard to low-level mV signals?
How do the AM25T and the AM16/32B compare with regard to resistive bridge measurements?
How do the AM25T and the AM16/32B compare with regard to thermocouple measurements?
Does the CS210 need to be regularly replaced?
Does the CS210 require any regular maintenance?
What relative humidity (RH) reading from a CS210 would indicate that it is time to replace the desiccant packs in the enclosure?
What might cause the CS210 to report negative data?
Can the CS210 be connected to a multiplexer?
If the top section of a UT30 gets damaged, can just that section be replaced?
Can the anchor for the UT30 be set alone—without using the bottom 10 ft piece as a guide?
If the paper bag with the UT30 hardware gets lost, how can the hardware pieces be replaced?

Previous Next