All FAQs (1902 total: showing 1821-1840)
- How can the 229-L be calibrated?
- How are readings obtained from the 229-L?
- Is calibration of the 229-L available?
- If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
- To use a multiplexer with a CR10X and very low sensor signals (1 mV and lower), should an AM25T or an AM16/32 be used? For which sensor signal voltages and sensor impedances can the AM25T and the AM16/32 be used?
- How should the AM25T be used?
- Can the AM25T be connected to an analog input channel on a device other than a datalogger, such as a programmable logic controller (PLC)?
- What is the measurement resolution, in Hertz, of the AVW1, AVW4, or AVW100? Do these interfaces have any certifications of compliance?
- Does the AVW100 work with Edlog Instruction 28 or 131?
- How can the datalogger build a text string and send it out the RS-232 port?
- What is needed to write a simple program that will read two analog channels (0 to 10 Vdc)?
- When dialing up the 21X, the barometric pressure data is displayed in real time. When the data is collected via either dial-up or a storage module, the barometric data are all zeros. Why does this happen?
- Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a datalogger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
- Does Baler 2.2 work with a CR800? Is a more recent version of Baler needed?
- In what format does the Baler Client Software save the data? Are there format options?
- Is there a patch for the current version of Baler?
- When trying to start LoggerNet, what might cause the "Unable to start program because the Campbell Scientific communications server is already running" message?
- After installing an upgrade to the current version of LoggerNet, why does the Toolbar no longer show all the buttons?
- Does PConnectCE work with Windows Mobile 5.0?
- Why is the battery in the BP12 and BP24 assembly taller than the bracket?
Previous
Next