All FAQs (1902 total: showing 1781-1800)
- Where is the interface cable for the WindSonic?
- Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
- Can the WindSonic produce an output of 4 Hz or higher frequency?
- The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
- Is it possible to connect a sonic anemometer and an electronic compass to a smart datalogger to give wind speed and direction on a non-fixed platform?
- If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
- Can the CR1000 or CR3000 communicate over TCP/IP?
- Can the CR1000 measure 4 to 20 mA signals?
- What would it take to make the CR1000 wireless?
- Is a separate extension cable for a 05106-L available? The current cable is approximately 13 ft long, and it would be helpful to extend the cable another 20 ft.
- What is the power consumption (mA) of the 05103-L, 05103-45-L, 05305-L, and 05106-L anemometers?
- What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
- What is the voltage output range for the 21X?
- If the 21X was turned off before the data was downloaded using PC208W, what can be done?
- Do the 21X dataloggers have a built-in security code that might be activated under certain conditions when upgrading the program?
- Can the CR5000 store data with a rate of 1000 Hz?
- What happens to a 21X program when the batteries fail?
- Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
- How do the 014A-L 3-Cup Anemometer and 03101-L Wind Sentry Anemometer compare?
- Using a 229-L with a CR1000, can the system be programmed to read the equilibrium soil temperature before excitation for a matric potential measurement?
Previous
Next