All FAQs (1902 total: showing 1661-1680)
- Why do the example programs for the WXT520 use a scan rate of 5 seconds?
- Why do the values from the WXT520 seem to be out of order?
- If the wind speed on the WXT520 constantly reads 0, what should be done?
- Is LoggerNet software needed to download the data from a datalogger remotely?
- What connects to the datalogger RS-232 port?
- Can the constants located within the ConstTable/EndConstTable instructions be edited?
- Can the display timeout and contrast be programmed by the CRBasic Editor?
- Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
- Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
- How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU slave?
- Can the LoggerNet software used for a CR10X be used with a CR850 or CR800?
- Are custom menus displayed on the terminal interface?
- Is it possible to overwrite an existing array using a CR850?
- Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
- Can the CR850 be programmed to show information in the display without using the keyboard?
- Can a new program be installed on a datalogger using a laptop and PC200W?
- When no excitation is commanded, are the voltage excitation ports on the datalogger isolated from the datalogger ground?
- Instead of saving the data of a CRBasic datalogger to one large file, how can it be saved in daily, hourly, or half-hourly files?
- If a laptop does not have any serial ports, how can LoggerNet talk to the datalogger?
- Can external devices be switched on and off using a datalogger?
Previous
Next