All FAQs (1904 total: showing 161-180)
- Why did Campbell Scientific start using molecular sieve? Does it have the same effect as the previously used chemicals?
- Can molecular sieve be used in the future to replace bottles for gas analyzers sold before July 2017?
- If a CS110 electric field sensor is installed in complex terrain, such as on a ridgeline in alpine territory, what is the effective range (spatial range) of the instrument, and how might it differ from a flatland site?
- Does the CR1000X have a Thermistor() instruction similar to the CR6?
- In the event that the CR1000X becomes damaged and needs a new wiring panel, what should be done?
- How does the power usage of the CR1000X compare to the power usage of the CR1000 or CR6?
- Can a program written for a CR1000 be used on a CR1000X?
- Can a CS320 be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?
- How can the CS320 be mounted if the 18356 leveling base is not used?
- Is it possible to read the output from a CS320 in a 4 to 20 mA form?
- On routine site visits, how can the calibration of the CS320 be checked?
- How often does the CS320 need to be recalibrated?
- What is the difference between a thermopile pyranometer and a silicon photocell pyranometer?
- How can an end user simulate a lightning strike to an SG000 or CS110?
- If a CH150 or PS150 is hooked up to both solar and ac power supplies, which power supply does the device use?
- Which software updates are free?
- Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH well suited for all environments?
- In terms of a network link interface, what is "bridge mode"?
- For the CPEC200, is the heater on the vortex intake controlled the same way as it was prior to the addition of the vortex intake?
- Has the vortex intake changed the way the pump for the CPEC200 works?
Previous
Next