All FAQs (1927 total: showing 1341-1360)
- What are the different cable termination options available for Campbell Scientific sensors?
- What are the different cable length choices available for Campbell Scientific sensors?
- Can leads for the CMP6-L, CMP11-L, or CMP21-L be ordered in a length of 300 ft? If so, is this a single, continuous cable, or are there two different cables that are joined together?
- Do the CMP6-L, CMP11-L, and CMP21-L require a power supply?
- To create a network of accurate solar irradiance measurements, do all of the stations need a Secondary Standard pyranometer?
- Are the CMP6-L, CMP11-L, and CMP21-L similar in accuracy and measurements?
- How can measurements be made using a 107, 108, or 109 temperature sensor/probe with a measurement device other than a Campbell Scientific datalogger?
- For the 107, 108, and 109 temperature sensors/probes, where within the white cylinder is the thermistor actually located?
- Should the dome of the LP02-L be cleaned regularly?
- If a LP02-L is reporting 0 W/m2, NANs, or unrealistic values, should it be recalibrated?
- Does the LP02-L need to be calibrated?
- What instruction should be used in CRBasic for the LP02-L?
- What type of signal does the LP02-L produce?
- What does the LP02-L measure and in what quantities?
- Is the SDM-SIO4 internal battery user replaceable, or does it need to be sent to Campbell Scientific for replacement?
- How can an SDM-SIO4 and a CR1000, CR3000, or CR800-series datalogger be used to send a string from the SDM port out?
- Is an SDM-SIO4 necessary to connect a CR1000, CR3000, or CR800-series datalogger with a serial sensor?
- Why does the graph in LoggerLink not display any historical data?
- Can data be collected from a datalogger using a USB cable with LoggerLink on an Android or iOS device?
- What equipment is needed to link dataloggers to a LoggerLink application?
Previous
Next