All FAQs (1904 total: showing 1301-1320)
- How can the IRGASON or EC150 recover more quickly from precipitation, dew, or frost?
- Can a fine-wire thermocouple be used with the IRGASON or EC150?
- If getting a span gas is difficult, can the analyzer just be zeroed?
- What kind of gases need to be ordered to zero and span an analyzer?
- If the sonic temperature is reading a couple degrees different from the IRGASON or EC150 temperature probe, is that a problem?
- When should the enhanced barometer be selected over the basic barometer for the EC150 or IRGASON?
- Can a sensor cable be shortened?
- Can a sensor cable be replaced?
- How often should the CHP1-L be calibrated?
- How often should the CHP1-L window be cleaned?
- Does the CHP1-L have an internal temperature sensor?
- What type of tracker can be used with the CHP1-L?
- Is a two-axis tracker needed for the CHP1-L?
- Can the output signal from a CHP1-L be negative?
- Does the CHP1-L require a power supply?
- How does the CHP1-L work?
- What type of sensor is the CHP1-L, and what does it measure?
- What are the different cable termination options available for Campbell Scientific sensors?
- What are the different cable length choices available for Campbell Scientific sensors?
- Can leads for the CMP6-L, CMP11-L, or CMP21-L be ordered in a length of 300 ft? If so, is this a single, continuous cable, or are there two different cables that are joined together?
Previous
Next