The SC32B Optically Isolated Interface is used to connect the CS I/O port on a datalogger with the RS-232 port on a PC. This interface converts the RS-232 voltage levels of the computer to the CMOS le...read more
The SC929 is a cable interface between a datalogger and a computer. One end of the cable connects to the datalogger's CS I/O port. The other end connects directly to the 9-pin serial port of a compute...read more
The 17394 is a six-foot interface cable fitted with a USB connector on one end and a 9-pin pin (male) RS-232 connector on the other end. The USB connector attaches to the USB port of a PC. The RS-232...read more
The SC115 is a lightweight, portable, 2 GB device that allows you to augment your onsite data storage or to transport data between the datalogger and PC. It is used with our newer dataloggers, and it...read more
The SC9 cable is used to connect from a PC or laptop RS232 port to a CS I/O port of the array based family dataloggers (CR510, CR10X, CR10, CR500, CR23X)). This cable cannot be used with the new table...read more
