FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

Why are some tubes difficult to connect, requiring a wrench to completely tighten the nut? Can something be done about this?

The threads on the nut and fitting have likely been damaged because they were over tightened. Replace both the nut and the fitting.

This was helpful

FAQs Home

Similar FAQs

How is PakBus Networking mode different from Transparent Communications mode?
Can multiple CS547A-L probes be wired to one datalogger if there is one A547 interface for each probe?
Does the LoggerNet license allow the migration of an installation from one computer to another? If so, what is the process?
How much does a typical system cost?
Does CRBasic have to be used to program a datalogger? Does a menu-driven program generator exist for the datalogger?
What is the minimum scan interval of the CR1000, CR800, CR850, or CR3000?
Can two different communications paths to one datalogger be set up in LoggerNet?